Lock iconRectangle 1Rectangle 2 + Rectangle 2 CopyShapeRectangle 1

Television and Audio Suggestions

Although all our inverters are shielded and filtered to minimize signal interference, some interference with your television picture may be unavoidable, especially with weak signals.

Here are some suggestions that may improve reception:

1. First make sure that the television antenna produces a clear signal under normal operating conditions (i.e., at home plugged into a standard 110AC wall outlet). Also insure that the antenna cable is properly shielded and of good quality.

2. Change positions of the inverter, antenna cables and television power cord.

3. Isolate the television, its power cord and antenna cables from the 12 volt power source by running an extension cord from the inverter to the TV set. Insure that any excess AC power cord is a distance away from the TV set.

4. Coil the television power cord and the input cables running from the 12 volt power source to the inverter.

5. Attach a "Ferrite Data Line Filter" to the television power cord. More than one filter may be required. These are available at electronic supply stores including Radio Shack (Radio Shack Part No. 273-105)

NOTE: Some inexpensive audio systems may discharge a slight "buzzing" sound when operated with an inverter. This is caused by deficient filters in the audio system. The only solution to this problem is using a sound system with a higher quality power supply.


More Questions? (Back to FAQ)


Sold Out